How To Clean Above Ground Pool After Winter

After a long and cold winter, you must clean your winter pool before opening it for the season. In this article, you will learn how to clean your above ground pool after the winter.

The cleaning procedure needs some preparation and effort. Deep cleaning is necessary regardless of whether you have purchased a pool cleaner.

Even the best pool cleaning equipment won’t be able to keep up with the winter. Pool preparation for summer is not as simple as it appears.

However, if you prepare ahead of time and put in the effort to complete the task, you will certainly succeed.

Swimming pool water purity is critical for your health and pool safety. Your pool will most likely have algae development and germs if it is not adequately cleaned and maintained. You’ll need to work for a few days.

You may enjoy the sunny and scorching summer days while ensuring that your pool is disinfected and clean after the winter.

We’ve compiled a list of crucial ideas and measures for cleaning and preparing your pool after the winter season. Read on to know more!

How To Clean The Above Ground Pool After Winter

How To Clean The Above Ground Pool After Winter

1. Prepare Your Chemicals and Supplies

It’s easier to start cleaning and treating the water if you have all of your materials on hand.

Based on your water test findings, you may require a few chemicals in addition to the pool shock to balance your water chemistry.

You can get everything you need in a starter chemical kit, but you can also buy each chemical separately.

2. Remove The Pool Cover

First and foremost, we must remove the pool cover before we can begin cleaning the pool.

  • If you used a pool cover during the winter, now is the time to take it down and store it.
  • First, remove any rubbish, leaves, and water accumulated on the surface.
  • With a bucket, scoop out any extra water that has gathered on the tarpaulin, or if a pump is available, briefly pump it off.
  • After that, you can remove the pool cover.
  • Clean the soiled pool cover briefly and stow it dry to be used again in the fall when the pool is winterized.
  • Remove the air or pressure cushions from the pool at the end.
  • Hang to dry in a location where it will be entirely dry.

3. Inspect Your Pool Thoroughly

Inspect Your Pool Thoroughly

Once the pool cover is removed, inspect your pool thoroughly. Look for:

  • Splits
  • Cracks
  • Tears
  • Stains
  • Other indicators of deterioration

You must also check for any algae and bacterial growth when the temperature of the water rises.

4. Do Not Empty The Pool

Unless it’s an emergency, you don’t need to empty the pool.

It’s not good to empty your pool, especially if it’s an indoor pool. It can ruin the pool by emptying it only to replace the water.

  • If your pool is built on dirt and has a high water table, it can elevate it out of the ground without the weight of the water holding it in place. It could result in a costly restoration.

However, it can be prevented by knowing how to clean your above ground pool correctly after the winter. A pool cover that perfectly fits your pool can keep the filth and debris out during the harsh winter months.

Ensure you have that every time you close it, so you don’t have to drain all the water when you wish to reopen it.

5. Ensure Water Circulation

Algae quickly spread above the ground pool due to some water circulation problems.

Due to poor circulation, there is a dead spot.

Pool pumps circulate the water; however, they don’t do an excellent job due to the dead zones.

Use multi-directional returns jets to improve the situation, but have pool brushes on hand to manually circulate the water.

6. Turn The Pump And Filter Back On

Turn The Pump and Filter Back On

It’s good to inspect your filter and pump for any damage before turning it back on.

  • You may wish to clear any debris if it has become dirty during the winter.
  • Turn them on if everything seems good!

For the first several minutes, keep an eye on your filter and pump. It will guarantee that they are in good functioning order and no leaks.

After that, let everything run for a few hours to clear out any debris accumulated inside the pool throughout the winter.

There shouldn’t be much debris in the water if you have a good pool cover, but even if you don’t see much, it’s a good idea to let the pump and filter run for a time before you start swimming.

7. Scrub And Vacuum The Pool

After your pool has been thoroughly inspected, you may begin vacuuming and washing the interior of your pool.

  • Make sure your pool’s floor and walls are spotless.

Vacuum the pool while the pump is operating.

  • Debris should be below if you have a solid pool cover.
  • Brush along the edges, steps, and ladders, ensuring to get into corners and under objects, the vacuum can’t reach.

Allow at least one whole day for the pool pump to circulate water and filter out loose dirt.

  • Scrub the steps, walls, ladders, and any other areas your vacuum can’t reach with a pool brush.

8. Skim Your Pool

Debris lodged inside your filter and pump may have seeped into your water after turning them on. Before you add any starter chemicals, you’ll need to remove all of this debris so that your water is pure.

  • If you have an above-ground pool, you’ll need to vacuum the water and brush the walls and hard-to-reach spots. To save time, you might want to seek the assistance of a friend.
  • After you’ve cleaned the water and the walls, use a skimmer to eliminate any debris, floating leaves, or bugs that may have accumulated on the water’s surface while getting your equipment ready.

9. Check The Water Clarity

Check The Water Clarity

Using a tester to read Total Dissolved Solids (TDS) is critical for measuring water clarity.

  • TDS should be less than 2000 PPM.
  • Turn on the pump and keep an eye on it to check for leaks.

Swimmers’ skin and eyes can be irritated if the Dissolved Solids level is high.

10. Test And Balance The Pool Water

Getting the water balanced early on might help you keep it that way throughout the summer.

If the water level is low, you must increase it to the proper level before testing.

After the added water has cycled through the pool filtration system, check the Total Alkalinity (TA), salt, and chlorine levels in the water.

A water test can be done with test strips, but bringing a pool water sample to a pool supply business is also helpful.

They have the instruments and equipment essential to establish an accurate baseline for which compounds you will require.

When you’ve determined which chemicals are required for water balancing:

Before shocking the pool with chlorine, correct the:

  • alkalinity
  • pH
  • calcium hardness

Rather than using all of the chemicals in your starter kit, only utilize the ones you need to have a healthy water balance.

11. Shock Your Pool

Add chlorine shock chemicals to your pool before using to destroy algae spores and bacteria and ensure that the water is safe for you and your family to swim in.

After shocking the pool, you should have clear, clean water.

  • Read the manufacturer’s instructions to determine how many ounces of chlorine shock you’ll need for your pool size.
  • Remember that when you first open your pool for the season, it’s ideal for shocking the water twice.
  • You’ll want to shock your pool at night or as the sun sets, as sunlight can quickly burn off the shock.
  • When adding the chlorine, wear chemical-resistant gloves and safety goggles to protect your eyes and skin.
  • Instead of putting the product in your filter basket and perhaps damaging it, carefully stroll around the pool and apply the chlorine straight to the water.

When Is The Best Time To Clean The Pool After Winter?

When Is The Best Time To Clean The  Above Ground Pool After Winter
  • Most experts recommend only cleaning the pool after the winter from a water temperature of 59 ℉.
  • Most pool owners begin cleaning their outdoor pools in late March or early April, but this is not a problem with proper pool heating.
  • Cleaning a pool after the winter usually takes around two weeks, so if you start in April, you’ll be ready to start the new pool season in no time.
  • Furthermore, cleaning your pool after the winter depends on where you live. Pool owners in the south typically begin removing the remnants of winter from their pools a few weeks sooner.

Final Remarks

We’ve given you a step-by-step guide on cleaning an above-ground pool after the winter season.

You may use the steps outlined above to keep your pool clean and gleaming so you can enjoy it this summer.

After the winter, make sure you do a deep cleaning because it is vital for your health and the longevity of your pool.

Pool life can be extended by balancing the water and cleaning the bottom and walls.

Furthermore, the pool should be free of contaminants.

You should be on the lookout for germs or mold forming in your pool.

You and your family can swim safely and enjoyably this summer by following these guidelines on how to clean above-ground pool after winter.

Leave a Comment